A beginners Guide to Painting Walls

The secret to doing anything well is ensuring that the planning and decoration leave no room for surprises. This rule also applies to the job of applying a fresh cote of paint to your living room. If you fail to prepare correctly, you will run into all sorts of problems and may ultimately end up with a living room disaster. Let us prevent this disaster with our expert guide to preparing a room for painting.

Time to complete job: Preparing a room for a new coat of paint or paper will take at least half a day, including filling and smoothing old plaster.

Approximate budget: The basic tools and materials should cost less than £20 for most rooms.

You will need:
Sugar soap
Bucket and sponge
Rubber gloves
Interior plaster filler
Decorator's sealant
Filling knife
Sanding block or electric sander
Dust sheets
Step ladder
Dust mask

Tip: Before to begin, always protect yourself by using a dust mask and your floor by laying down dust sheets.

Step 1: Smoothing the surface Scrape off any flaking paint with a flexible filling knife and smooth the surface with a sanding block. For more tips on stripping back paint, see Paint Stripping. If there is wallpaper on the walls this will need removing. For tips on doing this, see Stripping Wallpaper.

Step 2: Repairing damaged plaster Sometimes patches of old plaster become loose or cracked. Pick out the loose areas with your filling knife and repair the areas with plaster filler. Work methodically over the whole room to make sure you have treated all the damaged areas. When the filler is dry, use an electric sander or sanding block to smooth any rough areas of plaster and blend in the new repairs. Very powdery plasterwork or new bare plaster should be coated with a coat of plaster sealer. Depending on the size that requires repairing, you may need to patch it up. Patching up plaster is beyond the scope of this article but detail of how to do this can be found on the UKTV website. Tip: In order to ensure as nice a finish around the door frames and skirting boards as possible ensure that no cracks are present. Ensure that you remove any debris such as flaking pain and anything else that does not belong and then seal the gaps by carefully applying the decorators sealant.

Step 3: Cleaning Wash off any black mould with a solution of household bleach and leave to dry. Heavy mould or tobacco stains should be covered with a sealer coat of Anti-Damp Paint. Tip: It's essential to treat the cause of mould and damp patches before redecorating.

Step 4: Lining Decide if the exposed walls need covering with lining paper. If the walls have large repair patches or lots of tiny hairline cracks, covering with plain lining paper will provide a smooth base for paint or wallpaper. Hang the paper just like ordinary wallpaper and leave overnight to dry. For more tips, see Wallpapering. Finally, remove any dirt and grease with sugar soap or hot water and washing-up liquid. Don't forget to wash the ceiling as well if it's going to be decorated.

Article Source: http://www.myaddirectory.com

UKTV's DIY Guides are a wealth of free information that you can count on to help you turn your dome into a nicer place to live.

If You want to use this article on your website then select COPY THIS ARTICLE in the Menu on the right side!

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated